Hi Chuck, Have you been trying to run the ADCPro GUI with the latest version of the EVM (PAMB-based instead of MMB0-based)? This older version of the EVM (hardware using MMB0 controller, and ADCPro software) has been obsoleted. The links to the MMB0 EVM version of the software have been removed from ti.com to avoid confusion. The current PAMB based EVM (should look like the image on ti.com) should only require the PAMB board to be connected to the PC without all these ADCPro installation steps, and the following link is what should be used for the GUI: The USB2Any or EV2400 aren't needed to use the EVM and the cloud evaluation software. If you get the "ERROR: Connection to BULK device timed out" message when running the cloud evaluation software, once the drivers have been installed following the steps outlined in the E2E links I shared previously, the EVM should then work with the cloud GUI. I was able to run the GUI with the EVM on different PCs without issues. Best Regards, Angel
↧