Hello Tom and Chris Buying a blank EEPROM and replacing it in the ADS1282EVM unit I have is something I would do if I need to. For me it is key to know if I can go on with my baseline development strategy or not. It would take me a few weeks as I will probably be busy with other projects and this one is not top priority schedule wise. Of course I would post the result on the thread. However, if you plan to test it yourselves anyway I will be happy to just wait and see. Is it the case? Concerning the discussion about EVM-PDK role in design development I understand your points. I am still a little bit surprised that there aren’t more designers trying to use the MMB0 to test their analog circuit, even if MMB0 was not intended for this purpose, but I guess it is just me. People may often assume that the difficulties are to be expected in the digital & sw side and, as far as digital is ok, the analog side of the circuit should just follow. It might be true, at least in some cases, I don’t judge. For me, when I see such a resolution and like -140dBfs* noise levels, I am so amazed it even works that I cannot help wanting to go step by step. Thank you for your fruitful and informative comments, Martí *(full scale amplitude signal is 0dB reference. Rough value, it depends on gain and filter bandwidth used)
↧