I have to connect 3 ADS1248 on same SPI bus. I have attached a schematic.
Each ADS1248 contain 3 strain gauge connections.
Since my circuit is battery operated so I have to keep power minimum.
I have kept CLK, DIN & DOUT on same SPI bus while CS,Start & Dout are different for each ADS1248
I have attached a piece of code & small algo page, if anyone can check it whether it is correct?
In Algo file: I missed one block which I later on edited with pencil.
(Please visit the site to view this file)
(Please visit the site to view this file)
