Hi,
I have been out of office so I apologize for the delay.
if you just need to reprogram the eeprom, attached is a zip file of the batch file and folder that we use to program the eeprom when the TSW1200 is manufactured. The batch file uses a cmd file that runs the Xilinx programmer and formatted mcs file for the eeprom is included. The two bit files are included as well. The batch file was developed way back for the ISE tools version 9.something, so the path names might need to be fixed to make the batch file work for newer Xilinx tools. Or you can program the mcs file into the eeprom manually.
This would be much safer than trying to make the bit files again from source code.
Regards,
Richard P.
