Hello Dave-san,
I found the mistake setting.
I had selected SPI Connection of EVM Communication,because customer used SPI.
(Tools⇒Options⇒Target⇒EVM Communication)
Then tried to select i2C Connection, the singal passed from I2S In to I2 Out.
So I have to verify the operation of the SPI again.
However, it did not work with SPI.
Please tell me setting of SPI mode.
I had set contents are as follows：
＊PPS setting:
1．EVM Communication ⇒ SPI Communication
＊EVM setting:
1. Ｗ１：Shunt Pins 1-2 for SPI
2. Ｗ２：Shunt Pins 1-2 for SPI
3. TP7,TP8：Mode1、Mode2⇒SPIMode
Best Regards
Y.Hasebe