Thanks for the reply!
Don't worry about it! I'm using the Evaluation Module EK-LM3S6965 and ADS8344EVM. I nedded connect some cables, they are; CS, DIN, DOUT, CLK, and GND. It's easy! The configuration of ADC hardware is like this;
W1 2-3
W2 Open
W3 1-2 (+5v)
W4 2-3 (GND)
W5 2-3 (External Reference=5V)
W6 1-2 (NC)
W7 2-3
W8 1-2 ( Chip select by software)
____________________________________
All connections are ok!
I can take some pictures, than I send to you. If you need! I have four channels oscilloscope, I think interesting to you check the signals.
By the way, I'm sorry, my inghish is not very well, I'm from Brazil and I'm learning yet.
Thank you Rafael.
Hercules Vidal