hi,
KW
Yes, I have. The VCP device is "USB Serial Port(COM6)" to be distributed in the device manager and it works well.
The step below:
1. installation --->\...\sbac113b\setup.exe.
2.run \...\Texas Instruments ADCs\ADS42xx_58C28 GUI\CDM20814_Setup.exe.
3.connect the USB cable to ADS4226EVM Board's J17
4.Window 7 64-bit system install the driver for the USB chip automatically.
5.open "ADS42xx/58C28 GUI v2.1" software, the USB Status can not be lit to green, then press the Reset USB button, the status is same as before.
What's wrong with my step? maybe some support packages should be installed before? the Data Capture Board is TSW1200EVM, I guess its driver will conflict with ADS4226EVM's driver? I have no idea...
I am very anxious to get your help.
I'll appreciate it so much.
buddy