Hi Niall, How are you? Please confirm with us that you are using ADS5296A EVM and TSW1400EVM on your test bench to run Full scale ramp test pattern. The data test results are captured from using TSW1400 GUI (of course including setting all the ADS5296A registers correctly.) right? If those conditions are correct, then please use the following two .ini files (one is used for 10bit mode, the other one for 12bit mode) needed to be loaded to under your computer's HSDC Pro file directory as: C:\Program Files (x86)\Texas Instruments\High Speed Data Converter Pro\1400 Details\ADC files Please save these two files inside. After that, please at first Exit your HSDC Pro GUI and then re-Run that HSDC Pro GUI again. When it asks you to "Select ADC ini file" please choose one of the files I sent to you according to your need. Hope they can help you to run and capture ADS5296A EVM correctly again. Thank you very much. Best regards, Chen (Please visit the site to view this file) (Please visit the site to view this file)
↧