Hi Ramesh,
What I cannot see from the schematic you sent is the analog inputs and how they are connected. You must make sure that no inputs can exceed the Abosolute Maximum Ratings of the MSC1210. For example, there is U6 which shows power coming from the 12V supply. I cannot tell if this device gets connected to the MSC1210, but if it does, you must make certain that the output of the INA does not inadvertantly float to some value above 5V or below AGND. This may require additional components to ensure this.
This requirement is also true for any digital signal that may be wired to the board. Also make sure that power supply transients from turn on or turn off do not cause an Absolute Maximum Specification to be violated.
Best regards,
Bob B