My intention is to request 16 samples of data at a time. I imagine that just hitting the START pin will initiate a conversion. Is there anything particular that you know of about this ADC I should know? Is there a mode or setting up registers that should be setup prior to conversions? I read other ADCs in the forum require special attention, and other folks make common mistakes. What are some common mistake(s)/Issues you have seen people experience when using the ADS1259? I hope my transition is seamless. I am working on a high visibility project and there is no room for mistakes or wrong assumptions. I am trying to learn as much as possible, and I am preparing for FW development as well.
↧