Hello everybody!
I got my ADS1298R ECGFE Board and the MMB0 last week! Now I tried to start testing the Resperation-App. For that I try to set the Registers like the description in the TI-Users Guide for the ADS1298R ECGFE Board. But I got some Problems to find all the Registers that are described in chapter 5.2.2 and 5.3.2.
In Chapter 5.2.2 there the User Guide tell me to set "VREF" to "VREFP" in the Resp Register. But in my LabView-App I can't find VREF. There are only
- Resperation Demodulation on CH1
- Resperation Modulation on CH1
- Respiration Phase and
- Resperation Control
In Chapter 5.3.2 the User Guide is telling me to set "Pulse Mode Enabled" to "Disabled" and "Lead-Off Comerator Power-Down" to "Enable". Both should be part of Config Register 4. But I can't find Switches that ar named like the User-Guide describes.
Las but not least. I didn't get a plot in the Resperation Window of the Analyses-Tool. I got a plot at the Scope-Window, like the USer Guide is showing me in Figure 38. The next Figure (Figure 39) shows me the lopass filtered Signal. How can I get this?
Thanks for you answer and friendly regards from Germany!
Andreas