Forum Post: ADS130E08 wiring opamp, fault detect, and voltage

Hello,

We need to integrate the ADS130E08 into our design and need assistance with wiring it to measure voltage and current. Does the OPAMPOUT need to be connected to to every channel even if the inputs could be very different (voltage on some channels and current on others simultaneously)? 

In terms of fault detection I am assuming that the pull up and pull down resistors would be placed right next to the ADC before any other components, is that correct?

Also would like to clarify if it is ok to run the whole chip, AVDD and DVDD, from the same 3.3v supply? 

Thank you!