Ahh, the device is 315, not 135 :) No wonder I couldn't find it.
I think the issue is more an OMAP question and how it interprets the CSI data.
The TVP will output either ITU601 data (no embedded syncs) or ITU656 (with embedded syncs). One issue here though is that the output of the TVP will be interlaced but the 315 does not have the ability to transfer the FID signal discretely. It will accept H & V though.
What you MIGHT be able to do is configure the TVP to ITU656 mode and enable the H & V signals too. In this case the 315 will send the embedded sync ITU656 stream to OMAP where it will be necessary to check and order the fields in software.
You cannot use the raw mode from the TVP unless your video source is monochrome, and even then you will still have the field issue.
Finally, the 315 uses 0xFF codes for synchronization (as does ITU656) but the sequences are different so there may be issues trying to send ITU656 streams over this CSI link.
This may be possible but I don't think it is a simple issue. It certainly is not a TVP5150 question though so I suggest re-phrasing the question and posting to the high speed serial forum. Your question is basically "Can I send interlaced video over the CSI link with the 315?"
BR,
Steve