Hi Gerhard,
Thank you for your question.
The board you have is up to date, however the documentation is incorrect (and is in the process of getting fixed).
**Correction**
The previous table below had a few assumptions about the application. Here is the full jumper list with descriptions (the default position is now consistent with the TLV320AIC3106)
Jumper | Default Position | Jumper Description |
JMP1 | Installed | Connects Analog and Digital Grounds. |
JMP2 | Open | Selects onboard EEPROM as Firmware Source. |
JMP3 | Installed | Connects onboard Mic to IN2L. |
JMP4 | Installed | Connects onboard Mic to IN2R. |
JMP5 | Installed | Provides a means of measuring IOVDD current. |
JMP6 | Installed | Provides a means of measuring DVDD current. |
JMP7 | Installed | Provides a means of measuring DVRDD current. |
JMP8 | Installed | Provides a means of measuring AVDD_DAC current. |
JMP9 | Open | When installed, allows the USB-MODEVM to hardware reset the device under user control. |
JMP10 | 2-3 | When connecting 2-3, mic bias comes from the MICBIAS pin on the device; when connecting 1-2, mic bias is supplied from the power supply through a resistor, which the user must install. |
JMP11 | Installed | When installed, shorts across the output capacitor on HPLOUT; remove this jumper if using AC-coupled output drive |
JMP12 | Installed | When installed, shorts HPLCOM and HPRCOM. Use only if these signals are set to constant VCM. |
JMP13 | Installed | When installed, shorts across the output capacitor on HPLCOM; remove this jumper if using AC-coupled output drive. |
JMP14 | Installed | When installed, shorts across the output capacitor on HPROUT; remove this jumper if using AC-coupled output drive. |
JMP15 | Installed | When installed, shorts across the output capacitor on HPRCOM; remove this jumper if using AC-coupled output drive. |
JMP16 | 2-3 | When connecting 2-3, IOVDD is set to +3.3VD; when connecting 1-2, IOVDD and DVDD are shorted at +1.8VD. |
**Correction**
Here is the list of jumpers to install:
Jumper | Position | ||
| 1-2 | 2-3 | |
JMP1 | Install |
| |
JMP3 | Install |
| |
JMP4 | Install |
| |
JMP10 | Do not install | Install | |
JMP12 | Install |
| |
JMP16 | Do not install | Install | |
The jumpers not listed should not be installed.
Regards,
~John